Digital Thermometer with Sensor Probe

Our digital thermometer helps to check the hot air preheat and extrudate temperatures, required by German DVS Standards Code 2207-4.

The DVS Standards are the recognised benchmark for plastic welding worldwide.

Technical Data:

Digital Thermometer:-

• Measuring range:    -50°C to +1150°C
• Resolution:    1°C
• Accuracy:    better than 1%
• Sensor:     NiCr-Ni, acc. to ½ DIN 43710, for plug-in operation
• Display:    approx. 13mm high, 3½ digit LCD
• Nominal temperature:    25°C
• Working temperature:    0°C to 45°C
• Atmospheric humidity:    0 to 80% r.F. (not condensing)
• Storage temperature:     -10°C to 70°C
• Power supply:    9V-battery type IEC 6F22 (included)
• Battery service life:     approx. 700 operating hours
• Low battery warning:     BAT displayed automatically in case of low battery
• Dimensions of case:    approx. 106(H) x 67(W) x 30(D)mm
• Weight:    approx. 150g (incl. battery)
• Sensor: NiCr-Ni

Temperature Sensor - Insertion Probe:-

• Accurate and thin temperature sensor
• Thin stylus on Ø1,5mm provides the very fast response time
• Measuring tip length 130mm, 1,5mm diameter
• Wire length 105cm
• Measuring range -65°C to 550°C
• Response time t90 = approximately 3 seconds

Please Note: The Digital Thermometer can also be used with the Calstik Precise Hot Air Measuring Device as approved by the TWI. This item is sold seperately and can be found under related products.

Important: Delivery Time is normally 5/7 working days on this item.